Dacor RNRP30GSNGH Installationsanweisungen

Verifying the Correct Setup

Before using the range, read the accompanying Use and Care 

Manual completely. It contains Important safety, service, and 

warranty information.
1.  Before beginning this test procedure, ensure that all cooktop 

control valves are 

OFF, and all burner rings, burner caps, and 

grates are properly placed on the cooktop. 

2.  Turn the gas supply 

ON at the shut-off valve.

3.  Plug the power cord into an electrical outlet. When the range 

is first connected, the oven indicator light flashes for about 10 

seconds while the range’s circuitry begins. 

4.  Wait for the light to stop flashing before going to Step 5.
IGNITION TEST:
5.  Test a burner by pushing the knob and turning it to 

HIGH.

• 

It may take up to FOUR seconds for ignition, at which time 

the ignitor will stop sparking. If ignition does not occur within 

FOUR seconds:
• 

turn the knob to OFF, wait for at least five minutes to 

allow any gas to dissipate, then repeat the ignition test. 

6.  After ignition, rotate the control 

knob from 

HIGH to LOW to adjust 

the flame. 
When the range is correctly 

installed, the flame will be steady 

and quiet. It will also have a 

sharp, blue inner cone that will 

vary in length proportional to 

the burner size. Dacor’s Smart 

Flame™ feature reduces the 

flame under the grate to increase 

the life of the grate. If the range is equipped for 

use with LP gas, the ends of the flame may be 

yellow, which is normal.

7.  Turn the control knob to 

OFF. 

8.  Repeat the ignition test for all the remaining 

burners. After testing, turn them off.

9.  Open the oven door(s). Test the oven light(s) by turning the 

light switch(s) on the control panel.

10.  Turn on the convection fan switch(s). You should hear the 

convection fan, located behind the screen at the back of the 

oven, come on.

11.  With the oven door open, turn the oven temperature setting 

to 400 °F. Both the knob and the oven ON indicator light next 

to the knob should illuminate. Within 60 seconds, you should 

hear the bake burner ignite below the oven floor. It should 

begin to give off heat.

12.  Turn the oven control knob to the BROIL position. The bake 

burner should turn off. Both the oven control knob and the 

oven ON indicator light should be illuminated.

13.  Within 60 seconds the IR burner on the ceiling of the oven 

should ignite and begin to give off heat.

14.  Turn the oven knob to the OFF position. 

1.  Verify that power and gas are supplied to the range.
2.  Check the electrical connections and gas supply to ensure 

that the installation has been completed correctly.

3.  Repeat the burner ignition test and/or oven test.
4.  If the appliance still does not work, contact Dacor Distinctive 

Service at (800) 793-0093 ex. 2822. Do not attempt to repair 

the appliance yourself. Have the model and serial numbers 

available when you call. See inside cover for location.

Dacor is not responsible for the cost of correcting problems 

caused by a faulty installation.

Removing the Range for Service

1.  Turn the gas supply valve to OFF.
2.  Disconnect the power cord from the electrical outlet.
3.  Pull the range out from the wall

Reinstalling the Range After 

Service

1.  Push the range into operating position, making sure the anti-

tip bracket is engaged (see page 11).

2.  Connect the power cord to the electrical outlet.
3.  Turn the gas supply valve ON.

Installation Instructions