Dacor RNRP30GSNGH Installationsanweisungen

Cabinet Layout

• 

All maximum and minimum dimensions and clearances 

shown in the diagrams below must be maintained for safe 

operation.

• 

Check the location where the range is to be installed. It 

should be placed away from drafts that may be caused by 

doors, windows and heating and air conditioning outlets. 

• 

To reduce accumulated smoke in the room, Dacor strongly 

recommends installation with a range hood or approved 

downdraft.

• 

To reduce the risk of fire or personal injury from reaching over 

a hot appliance, avoid cabinet installations directly above the 

range. If cabinet storage is to be provided, the risk can be 

reduced by installing a range hood that projects horizontally a 

minimum of 5 inches beyond the bottom of the cabinets.

• 

The range may be installed flush to the rear wall. Dacor 

strongly recommends installing a non-combustible material 

on the rear wall above the range and up to the hood or 

installation of a backguard. It is not necessary to install non-

combustible materials behind the range below the countertop 

height. Any openings in the wall behind the appliance or in 

the floor underneath it must be sealed.

Gas and Electrical Service

• 

The shaded area shown below denotes the location of the 

gas inlet and the electrical outlet. This is the recommended 

location. For replacement purposes, the location of the 

existing utilities may be utilized provided they do not interfere 

with the sides or rear of the range. Check local building codes 

for permissible gas valve locations.

• 

An external manual shut-off valve must be installed between 

the gas inlet and the range for the purpose of turning on or 

shutting off gas to the appliance.

• 

Access to the gas shut-off valve when the unit is installed.

• 

Access to the electrical outlet, when the range is in place.

• 

The gas supply piping and shut-off valve, and the electrical 

outlet must be located so they do not interfere with the range 

when it is installed.

• 

The electrical outlet and gas shut off valve must be located 

so that the range can be pulled out for service while the 

appliance remains connected.

Planning the Installation

RNRP30G 

ERV3015

ATKERV-RP30 (Required when 

using the 3-in backguard)

IMPORTANT: Read the ERV3015 Installation Instructions 

for duct and electrical installation requirements. Use only 

the Dacor downdraft model(s) specified above. 
ATKERV-RP30 Trim Kit is required.

• 

A downdraft with a 3-inch backguard requires adding 

the ATKERV-RP30 trim kit to create a uniform unit. 

• 

Install ATKERV-RP30 onto the back of the range.

• 

The ATKERV-RV30 trim piece on the back of the range 

will cover the downdraft chassis.