Dacor ER48D Installationsanweisungen

Electrical Connection (cont.)

Connecting an Appliance Cord to the 

Range - Where Local Code Permits

Do not connect the green appliance wire to the neutral (white) 

supply wire unless local building codes permit.

1.  Remove the range electrical access cover from the back of 

the range.

2.  If using a 4 wire connection, loosen the grounding screw and 

remove the neutral to ground jumper link.

3.  Remove the conduit bracket from the bottom of the range 

electrical box.

4.  Disassemble and remove the strain relief from the appliance 

cord (not included). Insert the tabs on the two parts of 

the strain relief into the hole on the bottom of the box and 

reassemble it so that the tabs are below the box and the 

strain relief itself is inside the box.

5.  Slide the end of the appliance cord into the strain relief from 

the bottom of the box.

6.  Connect the white (neutral) wire to the neutral terminal in the 

box.

7.  Connect the L1 wire to the L1 power supply terminal in the 

box.

8.  Connect the L2 wire to the L2 power supply terminal in the 

box.

9.  If using a 4 wire connection, connect the ground wire to 

the grounding screw inside the box using a loop or spade 

terminal.

10.  Tighten the strain relief so that the appliance cord is held 

snuggly in place.

11.  Replace the range electrical access cover.

Installation Instructions

Remove jumper on  

4 wire installations

Remove conduit  

bracket before strain  

relief installation

Strain relief

Reassemble with tabs 

below and clamp above

Bottom of range  

electrical box

L1 terminal

L2 terminal

L2 wire

Green wire

White wire

Strain relief

Neutral terminal

Jumper removed

Ground screw

L2

Neutral

Ground

L1

L1 wire