BlueStar BSMLSS58SS Installationsanweisungen

1. Install three wires: black, white and green (#16  AWG) in 1/2" conduit from the service panel to the hood junction box.

Power supply must be rated for 120v, 60Hz, 15 amps (minimum).

Remove junction box and selected knockout.  Then install the strain-relief (conduit) connector in the removable

back panel.  For PMLSS-28” & 34” run power line through single knockout at top and route to junction box

mounted on back.

Remove the junction box from the removable back panel.  Connect black wire to power-supply black wire, white wire

to power-supply white wire, and green wire to power-supply green wire.

Place all wiring connectors inside junction box and re-install on removable back panel.

2.

3.

4. 

2-1/2"

2-1/2"

2"

Knock Out Holes Location

3"

Knock Out Location

Knock Out Holes Location

Knock Out Holes Location

3"

2-1/2"

2-1/2"

2"

3"

Knock Out Holes Location

2-1/2"

2-1/2"

2"

7

Figure 6-A.

Figure 6-C.

Figure 6-D.

Figure 6-B.