Dacor DR30DI Installationsanleitung

All specifications subject to change without notice.

Phone: (800) 793-0093

www.dacor.com

Document # PGCI-026

Revised 12/07/11   Page 1/1

•  Observe all governing codes and ordinances during planning 

and installation. Contact your local building department for 

further information.

•  All appliances must be installed in accordance with the 

accompanying installation instructions.

Cutout tolerances: +1/16” (+1.6 mm), -0, unless otherwise stated

Stiffener

Cabinet

face*

Countertop*

* 

IMPORTANT: See Countertop/Cabinet Cutout Dimensions 

for countertop cutout dimensions.

** 

IMPORTANT: If  3 1/4 inch side panels are removed cabinet face

cabinet face must be flush with back of control panel. 

Back of

control

panel

ERV3015

raised vent

DR30DI range

3/8” min. (1.0 cm)

space behind

raised vent 

chassis to clear

stiffener

3/8” min. (1.0 cm)

flat countertop

overhang required 

behind cutout

3 1/4 inch

side panel**

Countertop height:

35 7/16" (90.0 cm) min.

37 1/4” (94.6 cm) max.

28 11/16” (72.9 cm)

Installed

20 5/8” (52.4 cm)

0” (0 cm) to

3 1/4” (8.3 cm)

0” (0 cm) to

5 3/8” (13.7 cm)

Removed

23 7/8” (60.6 cm)

0” (0 cm)

0” (0 cm) to

2 1/8” (5.4 cm)

On installations with a raised vent, when sliding the range into position, 

it will stop when the rear of the side panels or control panel contacts the 

notches toward the front of the countertop. The rear range trim will partially 

cover the front of the raised vent chassis in back. 

rear wall recommended

Non-combustible

countertop opening

cabinet opening

below countertop

29 1/4” (74 3 cm)

27 1/2” (69.9 cm)

30” (76.2 cm)

2 9/16” (6.5 cm)

10” Min.

(25.4 cm)

both sides

Countertop Height: Min: 35 7/16” (90.0 cm) Max: 37 1/4” (94.6 cm) 

Notch countertop

overhang to width of

cabinets

3/8” Min. (1.0 cm)

Countertop

overhang

raised vent  opening

H

Combustible side

wall above range

below countertop

To cabinet face

To countertop

 front

J K

A

B C