Whirlpool WOD93EC0AE Installationsanweisungen

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

■

Phillips screwdriver

■

Measuring tape

■

Hand or electric drill (for wall cabinet installations)

■

1" (2.5 cm) drill bit (for wall cabinet installations)

■

Level

■

Flat-blade screwdriver

■

UL listed or CSA approved conduit connector

■

UL listed wire connectors

■

#8-14 x 1" screws - single ovens (2), double ovens (4)

■

Two #8-18 x 

³⁄₈" screws - bottom vent

■

Four #8-18 x 

¹⁄₄" screws - bottom vent trim

■

Four #8-18 x 

³⁄₈" screws - double oven feet

■

Bottom vent

■

Bottom vent trim

■

Two feet - double oven

■

Two front feet - double oven

■

Four grommets - single ovens (2), double ovens (4)*

■

Foam strip - single oven**

Check local codes. Check existing electrical supply. See 
“Electrical Requirements.”
It is recommended that all electrical connections be made by a 
licensed, qualified electrical installer.
*Grommets not included with models KEBK171B, KEBK101B, 

KEBK276B, KEBK206B, KEBS179B, KEBS109B, KEBS277B, 
KEBS279B, KEBS207B, KEBS209B, KEBU109B and 
KEBU209B.

**Foam strip not included with double oven.

IMPORTANT: Observe all governing codes and ordinances. 

■

Cabinet opening dimensions that are shown must be used. 
Given dimensions provide minimum clearance with oven.

■

Recessed installation area must provide complete enclosure 
around the recessed portion of the oven. 

■

Grounded electrical supply is required. See “Electrical 
Requirements” section.

■

Electrical supply junction box should be located 3" (7.6 cm) 
maximum below the support surface when the oven is 
installed in a wall cabinet. A 1" (2.5 cm) minimum diameter 
hole should have been drilled in the right rear or left rear 
corner of the support surface to pass the appliance cable 
through to the junction box.

NOTE: For undercounter installation, it is recommended that 
the junction box be located in the adjacent right or left 
cabinet. If you are installing the junction box on rear wall 
behind oven, it is recommended that the junction box be 
recessed and located in the upper center of the cabinet.

■

Oven support surface must be solid, level and flush with 
bottom of cabinet cutout. 

■

Floor must be able to support a single oven weight of 
129 lbs (59 kg) for 27" (68.6 cm) models or 154 lbs (70 kg) for 
30" models (76.2 cm). 

■

Floor must be able to support a double oven weight of 
251 lbs (114 kg) for 27" (68.6 cm) models or 288 lbs (131 kg) 
for 30" (76.2 cm) models.

IMPORTANT: To avoid damage to your cabinets, check with 
your builder or cabinet supplier to make sure that the 
materials used will not discolor, delaminate or sustain other 
damage. This oven has been designed in accordance with 
the requirements of UL and CSA International and complies 
with the maximum allowable wood cabinet temperatures of 
194°F (90°C).

Ovens approved for this type of installation have an approval 
label located on the top of the oven. Refer to undercounter 
installation instructions for cutout dimensions and approved oven 
cooktop combinations (separate sheet).