Bosch SPE53U5XUC Bedienungsanleitung

Dishwashers may occasionally exhibit problems that are unrelated to a malfunction of the dishwasher itself. The
following information may help you with a dishwasher problem without involving a repair professional.

 

Dishwasher 
does not 
start

1. Door may not be properly latched.
2. Unit may not be turned on.
3. Unit not reset or previous cycle not com-
pleted.
4. Delay start engaged.
5. Interruption of electrical power supply to 
dishwasher or blown fuse.
6. The door may have been closed without 
first selecting a cycle.
7. Water supply may not be turned on.

1. Shut the door completely.
2. Press the main power switch to turn unit 
on.
3. To reset, refer to “Operating the Dish-
washer” in this manual.
4. To reset, refer to “Delay Start” section in 
this manual.
5. Check circuit breaker.
6. Select a cycle and press start.
7. Check and turn on water supply.

Dishwasher 
beeping (end 
of cycle sig-
nal)

1. Default factory settings alert the customer 
that the cycle is complete by beeping. This 
feature can be deactivated if so desired.
2. Water connection is lost.

1. To adjust the volume or deactivate, refer 
to the “Cycle Completion Signal” section in 
this manual.
2. Check and turn on water supply.

Display does 
not illumi-
nate or con-
sole lights 
are not on

1. A fuse may have been blown or circuit 
breaker tripped.
2. Door not closed or latched.

1. Check the fuse or circuit breaker box and 
replace the fuse or reset the breaker if nec-
essary.
2. Ensure door is properly latched and com-
pletely closed.

Dishwasher 
seems to run 
a long time

1. Incoming water is not warm enough.
2. Cycle time can vary due to soil and water 
conditions.
3. Rinse aid dispenser is empty.
4. Dishwasher connected to cold water sup-
ply.
Note: Refer to “Wash Cycle Information” section 
in this manual for typical cycle lengths.

1. Before starting a cycle, run hot water 
faucet at the sink closest to the dish-
washer.
2. Sensors in the dishwasher automatically 
increase the cycle time to ensure a good 
wash when heavy soil is detected.
3. Add rinse aid.
4. Verify dishwasher is connected to hot 
water supply plumbing.

Dishes are 
not getting 
clean 
enough

1. Spray arm movement obstructed.
2. Spray arm nozzles clogged.
3. Improper use of detergents.
4. Filters could be clogged.
5. Dishes are nested or loaded too close 
together.
6. Selected wash cycle is not suitable for 
food soil conditions.

1. Ensure that spray arm movement is not 
blocked by hand rotating spray arms before 
starting cycle.
2. Remove the spray arms and clean 
according to the “Care and Maintenance” 
section of the manual.
3. Increase or decrease detergent depend-
ing on the water hardness (refer to Table 
1).
4. Clean the filters according to the “Care 
and Maintenance” section of the manual.
5. Rearrange load such that water spray 
can reach all items in the dishwasher - see 
“Loading the Dishwasher” section of the 
manual.
6. Refer to “Wash Cycle Information” sec-
tion of the manual.