Heartland HCFDR23 Benutzeranleitung

Seite von 96
23
CHANGING THE WATER AND AIR FILTERS
Your refrigerator is equipped with separate water and air 
filtering systems. The water filter system filters all the water 
used to produce ice. The air filter removes odors and impu-
rities from the refrigerator compartment.
NOTE
The control panel includes controls to monitor the
status of your water and air filters. See the Controls
section for more information.
About your advanced water filter
The  filter system is tested and certi-
fied by NSF International to NSF/ANSI 
Standards 42 and 53 for the reduction 
of claims specified on the performance 
data sheet.
Do not use with water that is microbiologically unsafe or of 
unknown quality without adequate disinfection before or af-
ter the system. Systems certified for cyst reduction may be 
used on disinfected waters that may contain filterable cysts.
•  Rated Capacity - 240 gallons
•  Rated service flow - .5 gallons per minute
•  Maximum Rated Pressure - 100 pounds per square 
inch
•  Recommended Minimum Operating Pressure: 30 
pounds per square inch
•  Operating Temp.: Min. 33°F, Max. 100°F
Water filter
The water filter is located at the lower left side of the
fresh food compartment.
Replacing your  water filter
In general, you should change the water filter every six 
months to ensure the highest possible water quality. The 
Water Filter Status light on the Touch Panel prompts you 
to replace the filter after the six month time period has 
elapsed. The water filter status light on this model is not 
performance tested or certified by NSF.
If your refrigerator has not been used for a period of time 
(during moving for example), change the filter before rein-
stalling the refrigerator.
It is not necessary to turn the water supply off to change 
the filter. Be ready to wipe up any small amounts of water 
released during the filter replacement.
1.  Push the filter release button above the cartridge to 
disconnect it.
2.  Slide the old water filter cartridge straight out of the 
housing and discard it.
3.  Unpack the new filter cartridge and remove the two pro-
tective caps covering the inlet and exit of the filter. Slide 
the filter gently into the housing until it stops against the 
snap-in connector at the back of the housing.
Push water filter button
Water filter
button
Water filter 
cartridge
Replacement 
water filter
Remove two
protective caps
Figure 49
Figure 50