Summit SWC530LBISTADAX Benutzeranleitung

Seite von 12
 
4
INSTALLATION INSTRUCTIONS 
Before Using Your Wine Cellar 
Remove the exterior and interior packing. 
Before connecting the wine cellar to the power source, let it stand upright for 
approximately 2 hours. This will reduce the possibility of a malfunction in the 
cooling system from handling during transportation. 
Clean the interior surface with lukewarm water using a soft cloth. 
Install the handle on the left side of the door (see page 5). 
 
Installation of Your Wine Cellar 
This appliance is designed for free-standing or built-in (fully recessed) installation. 
Place your wine cellar on a floor that is strong enough to support it when it is fully 
loaded.    To level your wine cellar, adjust the front leveling legs at the bottom of 
the unit. 
Locate the wine cellar away from direct sunlight and sources of heat (stove, 
heater, radiator, etc.).  Direct sunlight may affect the acrylic coating and heat 
sources may increase electrical consumption.  Extremely cold ambient 
temperatures may also cause the unit to perform improperly. 
Avoid locating the unit in moist areas. 
Plug the wine cellar into an exclusive, properly installed and grounded wall outlet. 
Do not under any circumstances cut or remove the third (ground) prong from the 
power cord.  Any questions concerning power and/or grounding should be 
directed toward a certified or authorized products service center. 
 
Reversing the Door Swing of Your Appliance 
This appliance has the capability of the door opening from either the left or right 
side. The unit is delivered to you with the door opening from the left side. Should 
you desire to reverse the opening direction, please follow the instructions below: 
1.  Carefully lay the wine cellar on its back. Use cushioning to protect the floor and 
appliance. 
2. With the door shut, remove the two screws holding the bottom hinge to the 
door. 
3.  Carefully lift off the door. 
4.  Unscrew the top hinge pin and cover and move to the opposite side.