Dacor DR30DHNGH Handbuch

28

Cleaning the Oven Interior (cont.)

Cleaning the Optional Dacor Griddle and Grill

Clean the griddle/grill after each use. Wash it thoroughly 

in hot soapy water to avoid stains from grease build-up. 

The griddle/grill is coated with a non-stick coating for easy 

cleaning. Warm water and liquid detergent are all that are 

needed for cleaning. Remove stubborn spots with a non-

abrasive plastic mesh pad. To prevent scratching, do not 

use abrasives or abrasive cleaners. Use the soft side of a 

sponge to scrub it. Dry it with a lint-free cloth.

Replacing the Light Bulb

•  To prevent electrical shock and/or personal injury, 

make certain that the oven and light bulb are cool 

and that power to the range has been turned off 

at the circuit breaker panel or fuse box before 

replacing the light bulb.

•  Always make sure the lens cover is in place when 

using the oven. The lens cover protects the bulb 

from breakage.

•  Replacing the lens cover without lining up the cutout 

with the light socket will damage the light fixture.

•  Do not use a screwdriver to remove the lens.

Light bulb replacement is considered a homeowner 

maintenance operation. If the light does not work, before 

replacing it, please consult the Problem Solution Guide.

Do not touch the replacement halogen light bulb with 

your fingers. Halogen bulbs are sensitive to the oils 

from your hand. The oils from your hand will stick to the 

bulb and may cause it to burn out faster than normal.

1.  Replace the light bulb only with Dacor part number 

100429. See page 21 for ordering information.

2.  Turn off power to the range at the circuit breaker 

panel or fuse box.

3.  Hold your hand 

under the lens 

for support 

and gently pry 

it loose using 

a spatula or 

table knife. Pull 

the lens cover 

straight out.

4.  Grasp the old 

bulb and pull it 

straight out of 

the socket.

5.  Using a glove, insert the new bulb into the socket. 
6.  As you reinstall the lens cover, line up the cutout on 

the inside rim with the light socket. Gently press it 

into its original position.

7.  Turn the power to the range back on. Reset the clock 

(see page 10).

Care and Cleaning

Light  

socket

Lens 

cutout

Light bulb

Before You Call for Service

Problem Solution Guide - Cooktop

Problem

May Be Caused By

What to Do

Igniters do not spark.

Power not supplied to unit.

Have an electrician connect range to properly 

wired electrical connection.

Power to range is off.

Turn power on at junction box. Check for 

tripped circuit breaker or blown fuse.

Power outage.

Contact power company.

Wet or dirty igniter.

Clean according to Care and Cleaning sec-

tion.

No flame.

Igniter not working (no clicking 

sound).

Clean according to Care and Cleaning sec-

tion.

Wet or dirty igniter.

Clean and dry according to Care and Clean-

ing section.

Gas is turned off.

Make sure the gas supply valve is in the on 

position.

Gas supply interrupted.

Contact gas company.

Flame goes out at low setting.

Air intake holes obstructed.

Check to make sure air holes on range are not 

blocked. See page 4 for locations.

Low gas pressure.

Contact gas company for pressure test.