Maytag MGDX6STBW Installationsanweisungen

The location must be large enough to allow the dryer door to 

open fully.
A minimum of 5½" (140 mm) clearance is required behind 

the dryer for the exhaust vent with elbow. See “Venting 

Requirements.”

 

 

■

A location allowing for proper exhaust installation.  

See “Venting Requirements.”

 

■

A separate 30 amp circuit for electric dryers.

 

■

A separate 15 or 20 amp circuit for gas dryers.

 

■

If you are using power supply cord, a grounded electrical 

outlet located within 2 ft. (610 mm) of either side of dryer.  

See “Electrical Requirements.”

 

■

A sturdy floor to support dryer and a total weight (dryer 

and load) of 200 lbs. (90.7 kg). The combined weight of a 

companion appliance should also be considered.

 

■

Level floor with maximum slope of 1" (25 mm) under entire 

dryer. If slope is greater than 1" (25 mm), install Extended  

Dryer Feet Kit, Part Number 279810. If not level, clothes  

may not tumble properly and automatic sensor cycles may  

not operate correctly.

Do not operate your dryer at temperatures below 45°F (7°C).  

At lower temperatures, the dryer might not shut off at the end  

of an automatic cycle. Drying times can be extended.
The dryer must not be installed or stored in an area where it will 

be exposed to water and/or weather.
Check code requirements. Some codes limit, or do not permit, 

installation of the dryer in garages, closets, mobile homes, or 

sleeping quarters. Contact your local building inspector.
NOTE: No other fuel-burning appliance can be installed in the 

same closet as a dryer. 

/

/

/

/

A. Wide opening side-swing door

B. Wide opening hamper door

NOTE: Leveling legs should be 1/2" (13 mm) (to match height of  

3.6 cu. ft. capacity washer) or 1½" (38 mm) (to match height of  

3.8 cu. ft. capacity washer).

/

/

/

/

/

/

/