Maytag MFX2876DRM Datenbogen

4. Align the arrow on the water filter label with the cutout notch 

in the filter housing and insert the filter into the housing.

5. Turn the filter clockwise 90 degrees (

¹⁄₄ turn), until it locks into 

the housing.

NOTE: If the filter is not correctly locked into the housing, the 
water dispenser will not operate. Water will not flow from the 
dispenser. 

6. While the compartment door is still open, lift the filter up into 

the compartment. Then, close the filter compartment door 
completely.

7. Flush the water system. See “Flushing the Water Filter” in the 

“Water and Ice Dispensers” section.

IMPORTANT: If you do not flush the water system, you may 
experience dripping and/or decreased flow from the water 
dispenser. 

Press WATER FILTER to display the percentage of filter life 
remaining (from 99% to 0%). Press WATER FILTER again to 
return to the Normal screen. 

The water filter status lights will help you know when to change 
your water filter. 

■

ORDER (yellow) - it is almost time to change the water filter. 

■

REPLACE (red) - Replace the water filter. While you are 
dispensing water, “Replace” will blink.

NOTE: If a water filter is not installed or is undetected 
because it is not properly installed (locked into place), 
“Replace” and “--% remaining” will display on the control 
panel. Check the water filter.   

■

RESET the water filter status tracking feature. After you 
replace the disposable filter with a new filter, closing the filter 
compartment door will automatically reset the filter status 
tracking feature. See “Using the Controls.”

NOTE: “Replace” will remain illuminated if a filter is not 
installed or is installed incorrectly.

To purchase a replacement water filter, see “Accessories.”

Replace the disposable water filter when indicated on the water 
filter status display or at least every 6 months. If water flow to 
your dispenser or ice maker decreases noticeably, change the 
water filter sooner.   

1. Locate the water filter compartment in the right-hand side of 

the refrigerator ceiling. Push up to release and lower the 
compartment door. 

2. Turn the water filter counterclockwise (to the left), and pull it 

straight out of the compartment. 

NOTE: There may be some water in the filter. Some spilling 
may occur. Use a towel to wipe up any spills. 

3. Install the replacement water filter by following steps 2 

through 7 in the “Install the Water Filter” section.

An air filter is 15 times more powerful than baking soda at 
reducing common food odors inside the refrigerator. 

On some models, your refrigerator's accessory packet includes 
an air filter, which must be installed prior to use. 

Install the air filter behind the vented door, located on the rear 
wall near the top of the refrigerator compartment.

1. Remove the air filter from its packaging.

2. Lift open the vented door.

3. Snap the filter into place. 

A