Whirlpool WED7000DW-WW Benutzeranleitung

Touch and hold START/PAUSE to begin the cycle.

Promptly remove garments after cycle has completed  

to reduce wrinkling. 

You may adjust different settings,  

depending on what you are drying and 

how your are going to dry the item. See 

the “Cycle Guide” for detailed information.
NOTE: Not all options and modifiers are  

available with all cycles. Not all cycles  

are on all models.

Add additional options such as Static Reduce, End Beep, 

and/or Wrinkle Shield (on some models) by touching that 

option. If you will be unable to remove the load promptly, 

select Wrinkle Shield

™

 before touching START/PAUSE. You 

may select the “+ Steam” setting (on some models) to add 

a short steam cycle after 60 minutes to help smooth out 

wrinkles.
NOTE: Not all options and settings are available with all 

cycles.

If all your loads on all Automatic Cycles are consistently less 

dry or more dry than you would like, you may change the 

default settings to increase or decrease the default dryness 

level.
Your automatic drying settings can be adjusted to adapt to  

different installations, environmental conditions, or personal  

preference. This change is retained and will affect all of your  

Automatic Cycles, not just the current cycle/load. There are  

5 drying settings, which are displayed using the time display:

0  Much wetter clothes, 30% less drying time. 

1  Slightly wetter clothes, 15% less drying time.

2  Factory preset dryness level.

3  Slightly drier clothes, 15% more drying time.

4  Much drier clothes, 30% more drying time.

NOTE: The settings cannot be changed while the dryer  

is running or paused. The dryer must be in standby mode 

(power is off) to adjust the default settings.

1.  Before starting a cycle, touch and hold DRYNESS  

for 6 seconds. 

2.  Touch DRYNESS to select the dryness level shown in 

the time display: 0, 1, 2, 3, or 4. 

3.  Touch START/PAUSE to save the new dryness level  

setting. 

When you select Timed Dry, the default time appears in the 

display. Touch “+” and “–” to increase or decrease the time 

in 1 minute increments. Touch and hold to change the time 

in 5 minute increments. 
The default temperature may be changed by touching 

Temperature until the desired dry temperature is lit.
Steam Refresh Cycles (on some models):

Select Steam Refresh to reduce odors and light wrinkles in 

dry loads consisting of wrinkle-free cotton, cotton-polyester 

blends, common knits, and synthetics. If you will be unable 

to remove a load immediately, touch Wrinkle Shield

™

 to add 

up to 150 minutes of periodic tumbling. You may select the 

+ Steam setting to add a short steam cycle after 60 minutes 

to help smooth out wrinkles.