GE AVM4160DFBS Installationsanweisungen

  Find the studs, using one of the following methods:
  A.  Stud finder.

  B.  Use a hammer to tap lightly across the mounting 

surface to find a solid sound. This will indicate  

a stud location.

  After locating the stud(s), find the center by probing  

the wall with a small nail to find the edges of the stud. 

Then place a mark halfway between the edges.  

The center of any adjacent studs should be 16s or 24s 

from this mark.

  Draw a line down the center of the studs.
IMPORTANT:  The microwave must be connected to at 

least one wall stud.

  Open the box and fold back all four carton flaps fully 

against the carton sides. Remove the following items 

from the protective foam: installation instructions, 

filters, exhaust adaptor, damper, and the small 

hardware bag. Do not remove the foam protecting 

the front of the microwave oven.

  Then carefully roll the microwave oven and carton 

over onto the top side. The microwave oven should 

be resting in the foam.

Wall  

Studs

Center

Carton

  Pull the carton up and off the microwave oven. 

   Open the microwave oven door and remove the 

plastic sheet and tape from inside the microwave 

oven door. Remove the tape covering the turntable 

hub.

Foam

  Set the microwave oven upright. Remove and 

properly discard plastic bags and foam.

  The mounting plate is attached to the back of the 

microwave oven. Remove the two screws holding it 

to the microwave oven.  The plate will be used as the 

rear wall template and for mounting the microwave 

oven to the wall.