Electrolux EPWD15MB Installationsanweisungen

       CAUTION

EXCESSIVE WEIGHT HAZARD

To avoid back or other injury, have more than one person move 
or lift the washer or dryer.  

C) Attaching mounting hardware

D) Mounting washer or dryer

E) Installing or re-installing washer or dryer

Rock the pedestal from corner-to-corner to check for stability. 

3. 

Repeat leveling and rocking until all four (4) feet are sturdy on 

the floor and pedestal is level.

Without turning the rubber foot, lock each pedestal leg in 

4. 

place by tightening its lock nut tight against the pedestal base.

Attach each front clip to outer-most set of holes with 2 screws.

1. 

Using two or more persons, slightly tip the washer or dryer 

1. 

back and lift it onto the pedestal. Still tipped, slide the appli-

ance back against the rear brackets and gently set down the 

front so the appliance is between the front and rear brackets.

Insert “C” tab of each rear bracket into the widest slots on rear 

2. 

of pedestal. Orient bracket outward for washer mounting (image 

C2a). Orient bracket inward for dryer mounting (image C2b).

Install 2 screws through each rear bracket into aligning pedes-

3. 

tal holes.

Adjust the appliance side-to-side to align its mounting holes 

2. 

with the pedestal’s bracket holes. 
Install 2 screws through each rear bracket into the base of the 

3. 

washer (image D3a) or dryer (image D3b).

With the pedestal drawer open for better access, install a screw 

4. 

through each front bracket into the base of the washer or dryer.

Slide appliance/pedestal into place.

1. 

Check for levelness and rock all four (4) legs again. Repeat 

2. 

until level and solid.
Refer to Washer or Dryer Installation Instructions for complete de-

3. 

tails on installing water, drain, electrical, gas, or exhaust venting.

lock nut

tab

slot

tab

slot

outward

inward

3