Linksys RE2000 Benutzeranleitung

 

Linksys Wireless-N Range Extender

Featured only in the European versions of the extender.

Press and hold this button for about five seconds to  reset the 

extender to its factory defaults. You can also restore the defaults from 

the Administration > Factory Defaults screen in the extender’s browser-

based utility.

After initial setup, if you have client 

devices, such as wireless printers, that support Wi-Fi Protected Setup, 

then you can use Wi-Fi Protected Setup to automatically configure 

wireless security for your wireless network. To use Wi-Fi Protected Setup, 

refer to “Using Wi-Fi Protected Setup” on page 7.

              RE2000V2

(green)  Using Ethernet cables (also called network 

cables), this Ethernet port connects Ethernet network devices 

to your wireless network.
The green light turns on when an Ethernet device is connected 

and active on this port. The light flashes when the extender is 

sending or receiving data over the Ethernet port.

1.  Insert the Setup CD into a computer that is connected to the network 

router. You will need to be near the router or access point and have 

access to a networked computer.

Set up the extender close to the computer and router to ensure a 

strong wireless signal. You can move it to a different location later.

2.  When the Setup utility starts, read the license terms, then click Next. You 

are prompted to plug your extender into an electrical outlet.

3.  Connect your extender to an AC power outlet. Your extender searches for 

wireless networks. The list of networks is displayed.