Maytag MFX2876DRE Datenbogen

 

NOTE: Some moisture 
buildup is normal.

The room is humid. 

A humid environment contributes to moisture buildup.

The door(s) are opened often or not 
closed completely.

Allows humid air to enter the refrigerator. Minimize door 
openings and close doors completely.

The door is blocked open.

Move food packages away from door.

A bin or shelf is in the way.

Push bin or shelf back into the correct position.

Storing liquid in open containers

This adds humidity to the refrigerator interior. Keep all 
containers tightly covered.

The drawer is opened often or left 
open.

Minimize drawer openings and close drawer completely after 
use.

Poor door seal 

Ensure door seals are making full contact with the 
refrigerator cabinet to allow for an adequate seal.

Temperature controls are not set 
correctly

See “Using the Control(s)” for recommended temperature 
settings.

The refrigerator is not connected to a 
water supply or the water supply 
shutoff valve is not turned on.

Connect refrigerator to water supply and turn water shutoff 
valve fully open.

There is a kink in the water source line. A kink in the line can reduce water flow. Straighten the water 

source line.

The ice maker is not turned on.

Make sure the ice maker is on. See “Ice Maker and 
Ice Storage Bin.”

The refrigerator has just been 
installed.

Wait 24 hours after ice maker installation for ice production 
to begin. Wait 3 days for full ice production.

The refrigerator door is not closed 
completely.

Close the door firmly. If it does not close completely, see 
“The doors will not close completely.”

A large amount of ice was recently 
removed.

Allow sufficient time for ice maker to produce more ice. See 
“Ice Maker and Ice Storage Bin” for ice production rates.

An ice cube is jammed in the ice 
maker ejector arm.

Remove ice from the ejector arm with a plastic utensil.

A water filter is installed on the 
refrigerator.

Remove the water filter and operate the ice maker. If ice 
volume improves, then the filter may be clogged or 
incorrectly installed. Replace filter or reinstall it correctly.

A reverse osmosis water filtration 
system is connected to your cold 
water supply.

This can decrease water pressure. See “Water Supply 
Requirements.”

The ice cubes are hollow or 
small
NOTE: This is an indication 
of low water pressure.

The water shutoff valve is not fully 
open.

Turn the water shutoff valve fully open.

There is a kink in the water source line.  A kink in the line can reduce water flow. Straighten the water 

source line. 

A water filter is installed on the 
refrigerator.

Remove filter and operate ice maker. If ice quality improves, 
then the filter may be clogged or incorrectly installed. 
Replace filter or reinstall it correctly. 

A reverse osmosis water filtration 
system is connected to your cold 
water supply.

This can decrease water pressure. See “Water Supply 
Requirements.”

Questions remain regarding water 
pressure. 

Call a licensed, qualified plumber.