Samsung WAM350/ZA Benutzeranleitung

Attach the HUB's power cord to the power port on the rear of the HUB, and then plug

the power cord into an electrical outlet.

The power ( ) and the HUB ( ) indicators on the HUB's front turn on.

When the pairing indicator (

) begins to flash, plug the M3(s) into an outlet.

The pairing indicator on the M3 starts to flash.

If the HUB's pairing indicator does not flash, press the

spK Add

button on the rear of the

HUB.

note

If you are adding multiple M3s, connect all the M3's to electrical outlets. If you are not connecting all

the M3s, refer to pages 32~38.

Wait until the pairing indicator on the M3 stops flashing. If the M3's LED indicator turns

solid blue, pairing is complete. The M3 may also beep.

notes

Place each M3 at least 20 inches (50 cm) from the HUB when connecting them to the HUB.

Your smart device cannot connect to the M3 or the HUB if there is no wireless router.

To confirm you have a proper connection, check the pairing indicator on the front of the HUB.

- When you turn on the HUB for the first time, there is a 20 minute pairing period.

The pairing indicator (

) will blink for these 20 minutes or until pairing occurs. When you press

the

SPK ADD

button to pair additional M3s, the pairing period is reduced to 10 minutes. The pairing

indicator (

) flashes for 10 minutes or until pairing occurs. Turn on the M3 you want to pair while

the pairing indicator is flashing.

- If pairing mode has expired, press the

SPK ADD

button on the rear of the HUB to turn on pairing

mode again. Then, turn the M3 off and then on or press the

SPK ADD

button on the rear of the M3

to link the M3 to the HUB.

For a proper connection, connect the HUB to your router before turning on the M3.

- Connecting the M3 to the HUB may take a few minutes.

- There will be a brief sound when the connection is established.

4444