Whirlpool UXT4036ADW Installationsanweisungen

Gather the required tools and parts before starting installation. 
Read and follow the instructions provided with any tools listed 
here.

Remove parts from package. Check that all parts are included.

*For information on ordering, see the “Assistance or Service” 

section.

IMPORTANT: Observe all governing codes and ordinances.

■

It is the installer’s responsibility to comply with installation 
clearances specified on the model/serial rating plate. The 
model/serial rating plate is located inside the range hood on 
the left wall.

■

Range hood location should be away from strong draft areas, 
such as windows, doors and strong heating vents.

■

Cabinet opening dimensions that are shown must be used. 
Given dimensions provide minimum clearance. Consult the 
cooktop/range manufacturer installation instructions before 
making any cutouts.

■

This range hood is recommended for use with cooktops with a 
maximum total rating of 40,000 Btus or less.

■

Grounded electrical outlet is required. See “Electrical 
Requirements” section.

■

All openings in ceiling and wall where range hood will be 
installed must be sealed.

■

These range hoods are factory set for vented installations. 
Models that are capable of being installed as non-vented 
(recirculating) require charcoal filters. See the “Assistance or 
Service” section for information on ordering charcoal filters.

The installation of this range hood must conform to the 
Manufactured Home Construction Safety Standards, Title 24 
CFR, Part 328 (formerly the Federal Standard for Mobile Home 
Construction and Safety, title 24, HUD, Part 280) or when such 
standard is not applicable, the standard for Manufactured Home 
Installation 1982 (Manufactured Home Sites, Communities and 
Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local 
codes.

Flat-blade
screwdriver

Drill with 

¹⁄₈

" (3 mm), 

¹⁄₂

" (13 mm), 

and 1

¹⁄₄

" (3 cm) bits

Wire stripper

#2 Phillips
screwdriver

Pencil

#8-18 x 

⁵⁄₈

" 

(4.2 x 16 mm)
truss-head screws

#8-18 x 1"
(4.2 x 25 mm) 
flat-head screws

Drywall
anchors

Mounting
brackets

UL Listed/CSA 
Approved 
wire connectors

UL Listed/CSA 
Approved 

¹⁄₂

" (13 mm) 

strain relief

120V, 75W 
maximum, 
type E26 
incandescent lamp

Charcoal 
filter kit 
Part Number 
W10355450*

Power 
cord kit 
Part Number
W10355452*

Stainless steel
cleaner and 
polish 
Part Number 
31462A*