Avanti WDT35EC Benutzeranleitung

  Steps to replace water bottles 
•  Use a clean cloth to wipe off neck of bottle. 

•  Remove cap. 

•  Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on 

opening of bottle while placing in reservoir. 

•  Insert the water bottle on the water intake over reservoir opening so it settles properly on it. 

•  Wipe off any water which may have splashed on dispenser top. 
 
 
  Indicator Lights: 
Turn the cooling switch on. 
There are 3 indicator lights on the front of the unit.  POWER, COOL and COLD 
 
The POWER indicator light will glow indicating the unit is plugged in and the power switch is in the ON 
position. 
 
The COOL indicator light will glow after the Power Switch turned on, and the cooling process will 
begin.   When the water reaches the appropriate temperature the COOL indicator light will turn off and 
the cooling cycle will stop, then the COLD indicator glows.   When the temperature of the water in the 
reservoir rises above the appropriate temperature the COOL light will glow indicating the cooling 
system as begun. 
 
 

•  Wash the inside of the reservoir with a warm water and baking soda solution. The solution should 

be about 2 tablespoons of baking soda to a quart of water. 

•  The drip tray and water faucets should be cleaned with mild detergent and warm water. 
•  At regular intervals or once a month inspect the coils located across the back of the dispenser. 

Vacuum accumulation of dust or clean it with a soft bristled brush. 

 

•  If the water dispenser will not be used for a long period of time, unplug the power cord from the 

wall outlet. 

•  Drain the water through the faucets. 
•  Turn the POWER switch to the “OFF” position. 
•  Drain the water from the tank by removing the plug from the back of the dispenser. 

 

Unit should not be transported on the sides. Place it upright if possible and cover it with a blanket.