Frigidaire FHWC3025MB Benutzeranleitung

 

4 - 0.45 x 1.3 cm mounting screws

3¼” x 10” (8.3 x 25.4 cm) rectangular metal vent 

  system. 

NOTE: An optional 7” round duct kit is available. 

You can 

order this kit as part number 5304487139

.

2 - UL listed wire connectors

1 - 75W max, 120V incandescent light bulb

Wall or roof cap with damper to match vent system

Vent clamps/duct tape as required 

UL listed or CSA approved ½” strain relief

 

Drill

1¼” (3.0 cm) drill bit

⅛” (0.3 cm) drill bit for pilot holes

Pencil

Wire stripper or utility knife

Tape measure or ruler

Caulking gun and weatherproof  

  caulking compound

Flat-blade screwdriver

Phillips screwdriver

Saber or keyhole saw 

 

Two 2” (5.1 cm) wide filler strips. Length and 

  thickness determined by recess dimensions.

Four flat head wood screws or machine screws 

 with washers and nuts (to attach filler strips).

 

Observe all governing codes and ordinances.

Ensure that the electrical installation is adequate and in 

conformance with National Electrical Code, ANSI/NFPA 

70 (latest edition), or CSA Standards C22.1-94, Canadian 

Electrical Code, Part 1 and C22.2 No. 0-M91 (latest edi-

tion) and all local codes and ordinances.

If codes permit and a separate ground wire is used, it is 

recommended that a qualified electrician determine that

the ground path is adequate.

A copy of the above code standards can be obtained 

from:

One Batterymarch Park

Quincy, MA 02269

8501 East Pleasant Valley Road

Cleveland, OH 44131-5575

A 120 volt, 60 Hz., AC only, 15-amp, fused  

  electrical circuit is required.

If the house has aluminum wiring, follow the  

  procedure below:

Connect a section of solid copper wire to the  

  pigtail leads.

Connect the aluminum wiring to the added 

  section of copper wire using special co 

 

  nectors and/or tools designed and UL listed 

  for joining copper to aluminum.

Follow the electrical connector manufacturer’s recom-

mended procedure. Aluminum/copper connection must 

conform with local codes and industry accepted wiring 

practices.

Wire sizes and connections must conform with 

 the rating of the appliance as specified on the 

  model/serial rating plate. 

  The model/serial plate is located on the left side of 

  the range hood.

Wire sizes must conform to the requirements of 

  the National Electrical Code, ANSI/NFPA 70 (la 

  est edition), or CSA Standards C22. 1-94, Canad 

  an Electrical Code, Part 1 and C22.2 No. 0-M91 

  (latest edition) and all local codes and ordinances.