Marvel 15" Built-In Ice Maker - Black Cabinet and Black Door Benutzerhandbuch

NOTE

Step 1: Verify door alignment

Verify that the door is aligned correctly with the cabinet prior

to fabricating the custom panel. Failure to do so may result in

mis-alignment of the custom panel with the hinge bracket. The

door should be parallel to the sides and top of the refrigerator.

If alignment is necessary the door may be adjusted by loosen-

ing the 2 screws which secure the top and/or bottom hinge

adapter brackets, located on the top and bottom of the door

and adjusting the door side to side. Use a 5/32” allen wrench, for

this procedure. (See Figure 9 below). When finished aligning the

door, tighten the screws securely.

Hinge adapter bracket lo-

cated on the top and bottom

of the door.

Remove top

hinge pin to re-

move the door.

9/32”

(7mm)

Figure 9

Door should be

parallel to top

and sides of ice

machine.

Step 2: Remove door

Remove the top hinge pin from the hinge with an 1/8” allen

wrench. Remove the door by angling the top of the door out-

ward and lifting the door off the bottom hinge.

(See detail in Figure 9).

Step 3: Remove gasket

Lay the door on its front being careful not to scratch it. To gain

access to the screw holes remove the door gasket by peeling up

and out of the channel.

Step 4: Cut overlay panel

Depending on the ice machine model cut the overlay panel to

the dimensions shown in Figure 10.

305/16”

(77.0cm)

145/8”

(37.1cm)

Front of

overlay

panel

Figure 10

For model 25iM

Step 5: Drill hinge clearance holes in overlay panel

Set the overlay panel on the door front, align the edges, and

clamp together. Clamp the panel firmly but be careful not to

damage the door or the panel. Mark center of hinge adapter

hole on wood panel, top and bottom. (See Figure 11.) Remove

wood panel from door and drill 5/16” (8mm) diameter clearance

holes into the overlay panels 3/4” (20mm) deep. These will be

clearance holes for the top and bottom hinge pins.

This is also a convenient time to locate and drill the holes for

your handle. Most often the handle is to match that of the sur-

rounding cabinetry. If your handle attaches from the back-side

of the custom panel, locate the mounting holes while the panel

is attached to the door and cabinet. After the panel is removed

from the door, drill the mounting holes from the front, to the

recommended diameter of the handle manufacturer. Counter

bore the back-side of the panel so the screw heads do not inter-

fere with the surface of the door.

For overlay with lock option panel thickness to be 3/4” (19mm)

maximum to 5/8” (16mm) minimum.

Weight of the overlay panel should not exceed 20 pounds (9.1

kilograms).

For the door to close properly, it is necessary to maintain a mini-

mum space of 9/32” (7mm) between the door and cabinet flange

(See Figure 9). This space can be adjusted by adjusting the top

and bottom hinge adapter brackets.

FULL OVERLAY PANEL INSTALLATION INSTRUCTIONS