Summit Built-In Commercial Kegerator - Black Cabinet/Diamond Plate Door Benutzerhandbuch
4
PLACEMENT AND INSTALLATION
Choosing the Right Place
To ensure that your beer dispenser works at the maximum efficiency it was designed
for, install it in a location where there are proper air circulation and electrical
connections.
for, install it in a location where there are proper air circulation and electrical
connections.
Choose a location where the beer dispenser will be away from any heat sources and
will not be exposed to direct sunlight.
will not be exposed to direct sunlight.
Remove all packing materials before using the beer dispenser.
Place the machine on a smooth, flat and sturdy surface.
Installation
Your appliance is designed for built-in use and features fan-assisted compressor
cooling. For optimum operation, however, we recommend providing an air gap of 2”
between the rear of the unit and the wall or counter surface. This will enhance cooling
and reduce energy waste. Also leave at least 1/8” on both sides and 1/16” at the top. Be
sure that airflow under the appliance is not blocked.
cooling. For optimum operation, however, we recommend providing an air gap of 2”
between the rear of the unit and the wall or counter surface. This will enhance cooling
and reduce energy waste. Also leave at least 1/8” on both sides and 1/16” at the top. Be
sure that airflow under the appliance is not blocked.
Connecting to Power Supply
Connect this appliance to a 3-prong power supply socket (which has a ground terminal).
If you only have a two-prong outlet, have it replaced by a qualified technician with an
outlet that meets the local codes.
If you only have a two-prong outlet, have it replaced by a qualified technician with an
outlet that meets the local codes.
D
O
N
OT
U
SE AN
E
XTENSION
C
ORD
Required nominal voltage and frequency are indicated on the rating plate. The
connection to the power supply and grounding has to be made according to current
standards and regulations. The appliance resists temporary voltage fluctuations with a
tolerance of
connection to the power supply and grounding has to be made according to current
standards and regulations. The appliance resists temporary voltage fluctuations with a
tolerance of
±10%.
Once connected, allow the appliance to operate empty for two to three hours before
putting a beer keg inside.
putting a beer keg inside.