Dimplex DF3015 Benutzerhandbuch

 
NOTE 1 
A 15amp, 120 volt circuit is required.  A dedicated circuit is preferred but not essential in all 
cases.  A dedicated circuit will be required if, after installation, the circuit breaker trips or fuse 
blows on a regular basis when the heater is operating.  Additional appliances on the same 
circuit may exceed the current rating of the circuit breaker. 
 
WARNING 
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure 
that the power cord is stored or secured to avoid tripping or snagging to reduce the risk of fire, 
electric shock or injury to persons.

 

Construction and electrical outlet wiring must comply with local building codes and other 
applicable regulations to reduce the risk of fire, electric shock and injury to persons.

 

Do not attempt to wire your own new outlets or circuits.  To reduce the risk of fire, electric 
shock or injury to persons, always use a licensed electrician. 
 

This section provides instructions for selecting a location and preparing the site to install the 
fireplace into your Dimplex mantel surround. 

1.  Select a suitable location that is not susceptible to moisture and is away from drapes, 

furniture and high traffic. 

2.  For ease of electrical hook up you may wish to locate the fireplace near an existing 

outlet. (refer to NOTE 1) 

3.  Store the fireplace in a safe dry and dust free location. 

 
NOTE 
The dimensions of the fireplace are 30 1/4”wide X 25 1/2” high X 10 1/2” deep.  The viewing 
area is 30 1/8” wide and 20 1/8” high.  The fireplace does not require any additional venting. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

3