Eagle Electronics 2 Benutzerhandbuch

44

detail seen on the sonar chart. Try this command only if you are in deep
water, traveling at high speed, and notice a reduction in detail on the
sonar chart. When Limit Search is turned on, the digital sonar will
limit its search for the bottom to the depth range you have set for the
sonar chart.

NOTE:

Turning Limit Search on can cause the digital sonar to lose the bot-
tom in some situations. The digital depth will flash if that occurs.

The sonar chart must be in manual depth range mode to use the Limit
Search command. To switch from auto depth range to manual, press

 until the 

 menu appears. Use the arrow keys to select the

desired range. When you're finished, press 

 to clear the menu from

the display.

Next, press 

 until the 

 menu appears, then

press 

 to enter the list of Chart Setup commands, where the

 menu appears. Press 

  to  turn  it  on  and  press

 to clear the menu.

Limit Search menu.

To turn Limit Search off, repeat the above steps but press the Down
Arrow to select "Off." Also remember to switch the depth range setting
back to automatic. This will restore the digital sonar's ability to auto-
matically track the bottom.

DIGITAL DATA SIZE FOR DEPTH, TEMPERATURE, SPEED,
and DISTANCE LOG
The size of the digital numbers for the depth, temperature, speed and
distance log can individually be changed to any one of three sizes. The
digital displays can also be turned off or on.