Electrolux 316471113 Benutzerhandbuch

, review the following list. It may save you time & expense. The list includes

common occurrences that are not the result of defective workmanship or materials in this appliance.

• Cabinets not square or are built in too tightly. Contact

builder or installer to make appliance accessible.

• Carpet interferes with appliance. Provide sufficient

space so appliance can be lifted over carpet.

• Be sure floor is level, strong & stable enough to

adequately support appliance.

• If floor is sagging or sloping, contact a carpenter to

correct the situation.

• Poor installation. Place oven rack in center of oven.

Place a level on the oven rack. Adjust leveling legs at
base of appliance until the oven rack is level.

• Kitchen cabinet alignment may make appliance appear

not level. Be sure cabinets are square & have sufficient
room for appliance clearance.

• Surface control knob has not been completely turned

to

 (lite). Push in and turn the surface control knob to

lite until burner ignites and then turn control knob to
desired flame size.

• Burner ports are clogged. With the burners OFF, use a

small-gauge wire or needle to clean ports. See
“Cleaning cooktop and parts” in the 

section for complete instructions.

• Appliance power cord is disconnected from outlet. Be

sure power cord is securely plugged into the electrical
outlet.

• Electrical power outage.

• Burner ports are clogged. With the burner OFF, clean

ports by using a small-gauge wire or needle.

• Moisture is present after cleaning. Lightly fan the flame

and allow burner to operate until flame is full. Dry the
burners thoroughly and follow instructions under
“Cleaning cooktop and parts” in the 

section.