Citizen Systems CL-S700 Benutzerhandbuch

42

Top Menu

Sub Menu

Default

Menu

Remarks

Emulation Select

DM4

DM4

Selects DataMax/Zebra compatibility

[Emulation Sel]

DMI

DM4: DataMax 400

DPP

DMI: DataMax IClass

ZPI2

DPP: DataMax Prodigy Plus
ZPI2: Zebra 2844Z

Emulation Auto

On

On

Setting emulation (Datamax/Zebra) auto

Detect

Off

detection.

[Emulation Auto]

AutoConfigure

On

On

Automatically configures optional devices.

[Auto Config]

Off

On .... AutoConfigure enabled (Regardless of

whether Function Select is set, if a
peeler or cutter is installed, each mode
is set automatically.)

Off ... AutoConfigure disabled (A peeler of

cutter is installed, but to not operate
the peeler or cutter, turn it Off and the
operation is selected by
Function Select.)

Function Select

Tear

Off

Selects the operation when the

[Function Sel]

Tear

AutoConfigure is set to Off. Designates the

Peel On*

paper position based on each option. The

Cut On**

operation of this device is enabled during
selection. At the same time, the parameters of
the f command of Prodigy Plus are emulated
for each optional device.

Cutter Action

Backfeed

Backfeed

Sets the cutter action.

Through

With the optional AutoConfigure On, printing
is executed only when the cutter is installed
or only when Cut is selected by Function
Select.
Backfeed is always set after cutting.
Through is set at the rear end of sheets 1 to
n-1 when the number of copies = n, and the
rear end of the final page of single sheet and
the copy is backfeed.

Paper Position

0.00 inch

Peel/Cut/Tear Off

Adjusts the stop position. It is based on the

0.00 mm

0.00 to 2.00 inch

inch/millimeter setting. There are initial

0.0 to 50.8 mm

values of the stop position for each device

Peel/Cut/Tear On

set above, and later, relative values are set.

-1.00 to 1.00 inch
-25.4 to 25.4 mm

Menu Key Action

Enters Menu

Enters Menu

Sets the menu key action.

Repeat Last One

Enters Menu:

Enters the menu setup mode.

Repeat Last One:

Last one is issued only for the final page.
In the case of a count, afterwards, only
last one is issued.

Note: Hold down the MENU key for at least 4
seconds in order to enter the Menu Setup
Mode when setting the “Repeat Last One”
menu.

RS-232C Baud

9600

115200

Setting the baud rate of the serial interface.

57600

• All settings related to the interface are

38400

enabled after the power is reconnected.

19200
9600
4800
2400

* Only when peeling option is mounted.

** Only when cutter is mounted.