Fortinet Network Router Benutzerhandbuch

You can use the web-based manager for the initial configuration of the FortiGate unit. 
You can also continue to use the web-based manager for all FortiGate unit settings.

For information about connecting to the web-based manager, see 

.

After connecting to the web-based manager you can use the following procedures to 
complete the basic configuration of the FortiGate unit.

Go to System > Admin > Administrators.

Select the Change Password icon for the admin administrator.

Enter the new password and enter it again to confirm.

Select OK.

Go to System > Network > Interface.

Select the edit icon for an interface.

Set the addressing mode for the interface.
Choose from manual, DHCP, or PPPoE.

Complete the addressing configuration.
• For manual addressing, enter the IP address and netmask for the interface.
• For DHCP addressing, select DHCP and any required settings.
• For PPPoE addressing, select PPPoE, and enter the username and password and 

any other required settings.

For information about how to configure these and other interface settings, see the 
FortiGate online help or the FortiGate Administration Guide.

Select OK.

Repeat this procedure for each interface.

Go to System > Network > DNS.

Enter the IP address of the primary DNS server.

Enter the IP address of the secondary DNS server.

Select OK.

Note:  If you change the IP address of the interface you are connecting to, you must connect 
through a web browser again using the new address. Browse to https:// followed by the new IP 
address of the interface. If the new IP address of the interface is on a different subnet, you may 
have to change the IP address of your computer to the same subnet.