Fortinet Network Router Benutzerhandbuch

From the web-based manager, you can use the setup wizard to begin the initial 
configuration of the FortiGate unit. For information about connecting to the web-based 
manager, see 

.

The first time you connect to the FortiGate unit, it is configured to run in NAT/Route 
mode.

Go to System > Status.

Select Change beside the Operation Mode.

Select Transparent in the Operation Mode list.

Select OK.

To reconnect to the web-based manager, change the IP address of the management 
computer to 10.10.10.2. Connect to port 1 and browse to https:// followed by the 
Transparent mode management IP address. The default FortiGate Transparent mode 
Management IP address is 10.10.10.1.

Select Easy Setup Wizard (the middle button in the upper-right corner of the 
web-based manager).

Use the information that you gathered in 

Select the Next button to step through the wizard pages.

Confirm your configuration settings, and then select Finish and Close.

If you changed the IP address of the management interface while you were using the 
setup wizard, you must reconnect to the web-based manager using the new IP 
address. Browse to https:// followed by the new IP address of the management 
interface. Otherwise, you can reconnect to the web-based manager by browsing to 
https://10.10.10.1. If you connect to the management interface through a router, make 
sure that you have added a default gateway for that router to the management IP 
default gateway field.

After you complete the initial configuration, you can connect the FortiGate-500A unit 
to your networks.

The FortiGate-500A has five 10/100Base-TX connectors (LAN, 1, 2, 3, and 4) and two 
10/100/1000Base-TX connectors (5 and 6) that can be connected to up to seven 
different network segments. You can connect them in any configuration. If you are 
configuring HA you can connect the FortiGate-500A to other FortiGate-500A units 
using port 4.