DISH Network HOME NETWORK Benutzerhandbuch
Page 8
Connecting the Satellite Receiver Using a HomePlug-to-Ethernet Adapter
Refer to Diagrams 5 and 6 and the instructions below to connect the satellite receiver to the router,
gateway, or Ethernet switch using a HomePlug-to-Ethernet Adapter.
gateway, or Ethernet switch using a HomePlug-to-Ethernet Adapter.
Diagram 5. Overview of Home Network with Receiver Connected by HomePlug-to-Ethernet Adapter
Diagram 6. Connecting the Receiver to the Router Using a HomePlug-to-Ethernet Adapter
Connect one end of the Ethernet cable to an available E
THERNET
(LAN) port on the router,
gateway, or Ethernet switch.
Connect the other end of the Ethernet cable to the E
THERNET
port on the back of the satellite
receiver, verifying the cable “clicks” into place. Check the lights on the receiver’s E
THERNET
port.
•
The green light should be lit indicating the E
THERNET
port is enabled and connected to an
active port on the router/switch.
•
The yellow light flashes whenever data is being received over the connected Ethernet cable.
Refer to Setting up the Receiver on page 10 to complete the installation and verify the receiver’s
Internet connection.
Internet connection.
Ethernet
Port
Port
Ethernet
Port