Snapper 1691827 Merkblatt

This kit provides an add-on light and required

a l t e r n a t o r   f o r   c o m p a c t   a n d   l a r g e   f r a m e
snowthrowers with Tecumseh engines. Kit can be
installed on snowthrowers that are equipped with
cabs (hard or soft). See the appropriate section for
installation instructions:

1. Drill a 

 hole, 

 from bottom and

centered (approx. 

 from either end) on the

crossmember as shown in figure 2.

2. Install light with capsorew, lockwasher, and nut

(lockwasher and nut towards rear).

3. Install alternator as provided in the Tecumseh

Installation Instructions. Use the appropriate

alternator shaft (F, figure 1) and self-tapping
screws (B).

4. Install clip and plastic ties as shown in figure 3.

This will prevent wire harness from interfering
with recoil starter.