Sunfire Classic Vacuum Tube Preamplifier Benutzerhandbuch
13
User's Manual
Phono Connections
System Configurations
The following pages show some typical
connections that you might make in your installa-
tion. They show how the inputs and outputs of
the Classic preamplifier are connected to
various audio components.
tion. They show how the inputs and outputs of
the Classic preamplifier are connected to
various audio components.
If your turntable is equipped with a Moving
Magnet cartridge, connect its audio outputs to
the preamplifier’s Moving Magnet inputs as
shown. Make sure that the MM/MC button is
in the OUT position.
the preamplifier’s Moving Magnet inputs as
shown. Make sure that the MM/MC button is
in the OUT position.
If you have a Moving Coil cartridge, use
the preamplifier’s Moving Coil inputs and push
the MM/MC button inwards.
the MM/MC button inwards.
System Configurations
In most cases, the turntable ground wire
should be connected to reduce any hum
heard in the speakers.
heard in the speakers.
Never connect a line-level source compo-
nent directly to the preamplifier’s MC or MM
inputs as they will be overloaded. They are
specially designed to handle only the very low
level outputs from a phono cartridge, and not
the higher voltage outputs from CD players or
other line level components. (Phono level is
usually below 100mV, whereas line level can
be up to 2 volts).
inputs as they will be overloaded. They are
specially designed to handle only the very low
level outputs from a phono cartridge, and not
the higher voltage outputs from CD players or
other line level components. (Phono level is
usually below 100mV, whereas line level can
be up to 2 volts).