Panasonic PV-GS9 Betriebsanweisung

Seite von 84
16
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at: http://www.panasonic.com/contactinfo
Before Use
•  Since the Battery will not be charged when the DC 
Cable is connected to the AC Adaptor, disconnect 
it from the AC Adaptor.
•  The [POWER] Lamp and [CHARGE] Lamp light 
up, and charging starts.
•  When the [CHARGE] Lamp goes off, charging is 
completed.
•  When the battery is completely discharged, the 
[CHARGE] Lamp blinks at fi rst, but the battery is 
charged normally. When the temperature of the 
battery is too high or low, the [CHARGE] Lamp 
blinks and the charging time becomes longer than 
usual.
• For other notes concerning this item, see page 61.
Disconnecting the Power Source
Set the [OFF/ON] Switch 
44
 to [OFF], and while 
sliding the [BATTERY RELEASE] Switch 
48
remove the Battery downward or DC Cable.
• When attaching or removing Battery, set the [OFF/ON] 
Switch to [OFF] and make sure the [POWER] Lamp 
is not lit.
Charging Time and Available 
Recording Time
CGR-D08R
A
1 h
B
2 h 10 min. (1 h 45 min.)
CGR-D14
A
1 h 30 min.
B
3 h (2 h 25 min.)
A
Charging Time
Maximum Continuous Recording Time
B
•  “1 h 30 min.” indicates 1 hour and 30 minutes.
•  Battery CGR-D08R (PV-GS9/PV-GS12/PV-GS14) 
or CGR-D14 (PV-GS15) is supplied.
•  The times shown in the table are approximate 
times. The numbers indicate the recording time 
when the Viewfi nder is used. The numbers in 
parentheses indicate the recording time when the 
LCD Monitor is used. In actual use, the available 
recording time may be shorter.
44
48
2  Attach the charged Battery to the Camcorder.
The Grip Belt
 To Use as a Grip Belt
Adjust the length of the Grip Belt to the size of your 
hand.
1  Detach the end of the Grip Belt.
2  Adjust the length of the Grip Belt to the size 
of your hand.
3  Reattach the Grip Belt.
•  The times shown in the table are for continuous 
recording at a temperature of 68 °F (25 °C) and 
humidity of 60 %. If the Battery is charged at a 
higher or lower temperature, the charging time 
may be longer.
•  The available recording time becomes shorter 
if you use both of Viewfi nder and LCD Monitor 
simultaneously when rotating the LCD Monitor 
forward to record yourself or setting [EVF 
ON/AUTO] to [ON].
How to remove the  Sensor tag
1  Detach the end of the Grip Belt.
2  Remove the Sensor tag. Then, replace the 
Grip Belt.