Panasonic PV-GS2 Benutzerhandbuch

Others

• Perform the DPOF Settings with your Camcorder.
• Verifying the DPOF Settings may take a little time. 

Wait until the Card Access Lamp goes out.

• The Lock Setting carried out by this Camcorder is 

only effective for this Camcorder.

• The SD Memory Card has a write protection switch 

on it. If the switch is moved to the [LOCK] side, you 
cannot write to or format the Card. If it is moved 
back, you can.

• Depending on your TV, nothing may be shown even 

if you correctly connect the Camcorder with your 
TV. In this case, set [AV JACK] on the [INITIAL] 
Sub-Menu to [OUT].

• Picture size may be displayed differently when 

playing back a Cinema picture on a wide-screen TV 
with Playback Digital Effect.

• When recording the Card Image on a Tape, its size 

is transformed into 720 x 480 pixels according to the 
DV format.

• If you attempt to record a still picture with a large 

image size on a Tape, there may be a reduction in 
the quality of the image.

• The blank section of a tape cannot be dubbed.
• Sounds sent through the DV terminal cannot be 

dubbed.

• If a tape has a non-recorded portion when the tape is 

dubbed, images and sounds may be disturbed when 
this portion of the tape is played back.

• If you set the tape counter back to 0 at the position 

where you want to stop Audio Dubbing so as to 
make it possible to use the Memory Stop Function

   (p. 66), Audio Dubbing is terminated automatically 

when the tape reaches this position.

• In the case of importing data recorded with Audio 

Dubbing to a PC using the PC’s software, only the 
original sound (ST1) may be imported, depending on 
the software.

• Regardless of the setting, digital dubbing is carried 

out automatically in the same audio recording mode 
as that of the playback Cassette.

• The images on the recorded monitor may be 

disturbed, but it does not affect the recorded images.

• Even if Playback Digital Effects, Playback Zoom, or 

Playback Title In have been used, these effects are 
not output from the DV terminal.

• Even if you use a device equipped with DV 

Terminals, you may not be able to perform Digital 
Dubbing in some cases.

• Date or other information to be displayed cannot be 

displayed if the software of the connected equipment 
does not support the display function.

• Water may cause the Camcorder or Cassette to 

malfunction. (Irreparable failure may occur.)

• If sea water splashes onto the Camcorder, wet a 

soft cloth with tap water, wring it well, and use it to 
wipe the camera body carefully. Then, wipe it again 
thoroughly with a soft dry cloth.

• If you use the Camcorder on or near a TV, images 

or sounds may be disturbed due to electromagnetic 
wave radiation.

• Do not use near a cell phone because doing so 

may cause noise to adversely affect the picture and 
sound.

• Recordings on the tape may be damaged, or images 

may be distorted, by strong magnetic fi elds created 
by speakers or large motors.

• Electromagnetic wave radiation generated by a 

microprocessor may adversely affect the Camcorder, 
causing the disturbance of images and sounds.

• If the Camcorder is affected by magnetically charged 

equipment and does not function properly, turn off 
the Camcorder power and detach the Battery or AC 
Adaptor and then connect the Battery or AC Adaptor 
again. Thereafter, turn on the Camcorder power.

• If you record pictures near radio transmitters or 

high-voltage cables, recorded images or sounds may 
be adversely affected.

• If you use the Camcorder for a long period of 

time, the internal temperature increases and, 
consequently, this may cause malfunction.

• This Camcorder is not intended for business use.