Otter Products q1 Merkblatt

If using a Q1 Ultra Premium skip to step 3.
If using a Q1 Ultra with standard 4-cell battery you will use both foam inserts.
If using a Q1 Ultra with extended 6-cell batter you will only need to use the foam labeled for the Q1U.

Remove the silicone skin from the hard shell.

Separate the two halves of the case.

Remove contents and set aside

For maximum protection the use of the clear membrane is recommended.

Two membranes are included with the case. One is for the Q1 Ultra and the other is for the Q1 Ultra Premium. 

The membranes are labeled on the lower right edge. Determine which membrane fits your device.

3.1 Quick Install: Align the clear membrane with the front of the device (1). 

To reduce air bubbles, it is recommended that you use the edge of a credit card and smooth out the surface (2). 

Note: To fully remove air bubbles see recommended install below.

3.2 Recommended Install: Fill a large drinking glass with water. Add one drop of dish soap and stir thoroughly (1). 

Add a small amount of the mixture to the tip of your finger and apply to the screen of the device (2). 

A very small mount of the mixture is needed - Do not over apply the mixture. 

Immediately align the front of the clear membrane with the keyboard and screen (3).

It is recommended that you do not touch the screen for 24 hours until the water can dry out.

Step 1

Step 2

To install the foam peel off the back of the foam and place it within the guides. 

Press firmly to secure the foam.

For additional help visit www.otterbox.com or call 888.695.8820

3.1 (1)

3.2 (1)

3.2 (2)

3.2 (3)

3.1 (2)