HP (Hewlett-Packard) HP E5200A Benutzerhandbuch
Using the Analyzer
To Connect to the System Under Test
To Connect to the System Under Test
2-2
To Connect to the System Under Test
1
Before you connect to the system under test (SUT), ensure that
•
the analyzer is connected to the controlling computer (workstation or
notebook PC)
notebook PC)
•
two interface pods are inserted in the analyzer, one of which may be a
blank pod
blank pod
2
Connect the interface pod(s) to the SUT. Each interface pod has a
transmit and receive connector on its front panel that you use to
connect to the SUT. See the Setting Up the Interface Pod guides for
specific details relating to your interface pods.
transmit and receive connector on its front panel that you use to
connect to the SUT. See the Setting Up the Interface Pod guides for
specific details relating to your interface pods.
Note
If you are using an optical interface pod, ensure that the connectors on the front
panel and the test cables are clean. Refer to the appropriate Setting Up the Interface Pod
guide for more information.
guide for more information.
Receive (Rx)
Transmit (Tx)