Ultimate Support Systems GS 100 Merkblatt

STEP 1
Turn stand upside-down and locate the 
RED / GRAY Locking Knob. Turn the Locking 
Knob ¼ turn counterclockwise to the open 
position shown above.

STEP 5
Flip open the RED / GRAY telescoping Lock 
Lever at the back of the stand. Adjust 
the height of the stand until your guitar’s 
bottom edge or instrument cable is about 
2 inches from the floor. Flip down the Lock 
Lever to set the height.

STEP 2
Turn the stand back to the upright position 
and fold all three legs down until they 
stop in the open position. (The legs should 
move freely to the open position, if they do 
not, make  sure the Locking Knob is in the 
open position.) 

STEP 6 for GS-100 (#13710)
Unhook the Retention Strap from the open 
position and pull strap around to the front 
of the yoke. Stretch the strap over the 
other end of the yoke to secure guitar. 

STEP 3
After all three legs are in the open position 
turn the RED / GRAY Locking Knob ¼ turn 
clockwise to the closed position 
shown above.

STEP 6 for GS-1000 (#16538)
Place guitar or bass into the stand and 
the instrument’s weight pulls the yoke 
closed around the headstock. To remove 
the instrument, simply lift up to release the 
security gate.

STEP 4
Rotate the Neck Yoke to the open  position 
shown above. The yoke should firmly snap 
into position.

STEP 7 OPTIONAL:  On GS-100 
Convenient guitar pick storage slots are 
located along the top of the yoke.

LOCKING

KNOB

OPEN

OPEN

CLOSED

CLOSED

LOCKING

KNOB