3com WX1200 3CRWX120695A Benutzerhandbuch

C

HAPTER

 11: M

ANAGED

 A

CCESS

 P

OINT

 C

OMMANDS

Radio 1 type

Radio 2 type

(cont.)

„

The following information appears for external antennas:

External antenna detected, configured as 
antenna-model—Indicates that an external antenna has 
been detected, and lists the antenna model configured 
on the radio. (MSS does not detect the specific model.)

External antenna detected, not configured—Indicates 
that an external antenna was detected but no external 
antenna is configured on the radio. 

External antenna not detected, configured as 
antenna-model—Indicates that an external antenna is 
configured on the radio but no external antenna was 
detected.

operational channel

The channel on which the radio is currently operating.

If the channel number is followed by (Auto), the value was 
set by RF Auto-Tuning.

operational power

The power level at which the radio is currently operating.

If the power setting is followed by (Auto), the value was set 
by RF Auto-Tuning.

base mac

Base MAC address of the radio.

bssid, ssid

SSIDs configured on the radio and their BSSIDs.

load balance

Whether RF load balancing is enabled for the radio.

current load

The load on this radio relative to the load balancing group 
average or target load.

Table 60   Output for display ap status terse

AP

The number of the MAP connected.

Flag

Operational status flags for the MAP.

For flag definitions, see the key in the command output.

Port

WX port number connected to the MAP.

Flg

Operational status flags for the MAP.

For flag definitions, see the key in the command output.

IP Address

IP address of the MAP. The address is assigned to the MAP by 
a DHCP server.

This field is applicable only if the MAP is configured on the 
WX switch as a Distributed MAP.

Table 59   Output for display ap status (continued)