Weber 5000 Series Benutzerhandbuch

Install the three back panels

You will need:  frame assembly and the three back
panels. (Number 2)

Place the bottom of one back panel on the back frame
connector, notches to the top. Set in place to the far left,
butting up against the caster frame. Figure 8.

Repeat the procedure with the other two back panels.
When in place they should be flush with each other..
Figure 9.

Wheel
frame

Caster frame

Install side burner locks

You will need:  frame assembly, two side burner locks and
a 7/16 inch wrench.

Loosen the right rear 1/4 x 20 bolt. Install the side
burner lock. The “U” shape cut out of the lock slips down
over the bolt. Tighten with a wrench. Figure 10 (a).

Loosen the right front 1/4 x 20 bolt. The side burner lock
fits between the front panel and the frame. 
The “U” shape cut out slips up over the bolt. 
Tighten with a wrench. Figure 10 (b).