Dacor ER30DSRSCH Benutzerhandbuch

Page

STEP 4:   Hold the left side panel in  

position on the side of the 
range. Locate the center 
mounting hole. Remove and 
retain the screw attached to 
the chassis beneath it.

STEP 5:   Insert the tabs on the trim 

piece into the slots on the 
range.

STEP 6:   Use the hex head screw (80) removed from the side, a Torx head screw removed from 

the kick panel and the hex screws from the kit to attach the side panel to the range. Three 
() hex head screws attach the side. One (1) Torx head screw (8709) inserts through the 
end cap hole to attach the top of the side panel. One (1) Torx head screw (8709) inserts 
through a hole in the front panel to attach the bottom of the side panel.

STEP 7:   Reinstall the end cap.

STEP 8:   Repeat steps  to 7 for the 

right side panel. NOTE: 
There is an additional hex 
screw (80) in the kit 
for the right side panel 
because the center mount-
ing screw is not reused as 
with the left side (do not 
perform step 4).

STEP 9: 

Reattach the kick panel 
to the range by snapping 
the ball studs on the back 
of the panel into the holes 
on the front panel of the 
range. Open the door and 
reattach the kick panel top 
screws removed in step 1.