DCS RDS-305 Benutzerhandbuch

Seite von 74
OVEN SELF CLEANING MODE
25
Turn on the ventilator hood above the range and leave it on until after the oven has completed the
self-clean cycle.
SETTING THE OVEN FOR SELF CLEAN
1) Push the “CLEAN” Selector Button.
2) Set Oven Control Knob to “CLEAN”.
Cooling Blower turns on,
OVEN ON light and HEATING light turn on,
LOCK light turns on,
The door closing process takes approximately 60 seconds to complete, at which 
time the door becomes locked.
AT THE END OF THE CLEAN CYCLE:
The clean cycle takes 5 hours to complete. The OVEN ON
light turns off once the cycle has finished.
1) Push the OFF selector button. The door latch will open
automatically after the oven temperature falls below 
550ºF and the automatic door lock completes its 
60 sec. cycle to the OPEN position.
2) Turn the oven control knob to OFF. Wipe white ash 
with a damp cloth or sponge (after oven has cooled) 
before placing oven racks.
3) Replace the oven rack slide assemblies by:
A) Guiding the rear of the rack slide assembly into the bottom rear bracket of the
oven side,
B) Guide the top rear of the rack slide assembly into the top U-shaped bracket of
the oven side,
C) Lift up the Push Rod so that it rests on the “ledge” of the side support of the 
assembly, and 
D) Screw the assembly secure to the oven through the hole in the front middle 
section of the side support. Repeat for the other side of the oven.
4) Replace the oven rack
WARNING:
The interior of the oven will still be at baking temperatures when the lock light
turns off and the oven door can be opened. Use caution as the oven may be hot
enough to cause burns.
Fig. 13