Frigidaire 316901300 Benutzerhandbuch

27

The cooktop and surface burners are designed to make

cleaning easier.  Since cooktop surface burners are sealed,

cleanups are easy when spillovers are cleaned up

immediately. Routinely clean the cooktop. Wipe with a clean,

damp cloth and wipe dry to avoid scratches. The contoured

well areas and burner drip pans (some models) should be

frequently cleaned also.

Keeping the burner head ports and slots clean will prevent

improper ignition and an uneven flame. Refer to the following

sections for further instructions.

To avoid possible burns use care when cleaning the

cooktop. DO NOT attempt to clean the cooktop whenever

the cooktop or burner heads are still hot.

To avoid possible burns DO NOT attempt any of the

cleaning instructions provided below before turning OFF

all of the surface burners and allow them to cool.

Each burner head has a small ignition port located as

illustrated. Should you experience ignition problems it may be

that this port hole is partially blocked with soil. With the burner

head in place, use a small wire gauge needle or the end of a

paper clip to clear the ignition port.

For proper gas flow it may be necessary to clean the burner

head and slots. To clean, first use a clean DAMP cloth to soak

up any spills. Remove any food from between the burner slots

using a small non-abrasive brush like a toothbrush and

afterwards wipe up using a damp cloth. For stubborn soils

located in the slots, use a small-gauge wire or needle to clean.

the cooktop
If a spill occurs on or in the recessed or contoured areas,

blot up spill with an absorbent cloth. Rinse with a clean,

damp cloth and wipe dry.

drip pans (some models)
Use a soap-filled scouring pad or a mild abrasive cleanser

to clean the burner grates, burner caps and surface burner

drip pans (if equipped).

The surface burner heads are secured to the cooktop

and must be cleaned in place on the cooktop.

For proper flow of gas and ignition of the burner — DO

opening. Always keep the surface burner cap and

surface burner head in place whenever a surface

burner is in use.

The light bulb is located at the rear of the oven and is

covered with a glass shield held by a wire holder. The glass

shield must be in place whenever the oven is in use.

1. Turn electrical power off at the main source or unplug

the range.

2. Press wire holder to one side to release the glass shield

that covers the light bulb.

3. Replace bulb with a new 40 watt appliance bulb.

4. Replace glass shield over bulb and snap wire holder

back into place.

5. Turn power back on again at the main source (or plug

the appliance back in).

6. The clock will then need to be reset. To reset, see

“Setting the clock” in this Use & Care Guide.

Be sure the range is unplugged and all parts are COOL before

replacing  oven light. Wear a leather-faced glove for protection

against possible broken glass.