Amana W10196156B Benutzerhandbuch

Seite von 12
5
COOKTOP USE
Electric igniters automatically light the surface burners when 
control knobs are turned to IGNITE.
Before setting a control knob, place filled cookware on the grate. 
Do not operate a burner using empty cookware or without 
cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise to IGNITE.
All 4 surface burners will click. Only the burner with the control 
knob turned to IGNITE will produce a flame.
2. Turn knob to anywhere between HIGH and LOW.
Power Failure
In case of prolonged power failure, the surface burners can be lit 
manually. Hold a lit match near a burner and turn knob 
counterclockwise to IGNITE. After burner lights, turn knob to 
setting.
Sealed Surface Burners
IMPORTANT: Do not obstruct the flow of combustion and 
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using a 
surface burner. A clean burner cap will help avoid poor ignition and 
uneven flames. Always clean the burner cap after a spillover and 
routinely remove and clean the caps according to the “General 
Cleaning” section.
Gas tube opening: Gas must flow freely throughout the gas tube 
opening for the burner to light properly. Keep this area free of soil 
and do not allow spills, food, cleaning agents or any other material 
to enter the gas tube opening. Keep spillovers out of the gas tube 
by always using a burner cap.
Burner ports: Check burner flames occasionally for proper size 
and shape as shown above. A good flame is blue in color, not 
yellow. Keep this area free of soil and do not allow spills, food, 
cleaning agents or any other material to enter the burner ports.
START
Cooking start
The Start pad begins any oven function. If Start is not pressed within 5 seconds, “PUSH?” or 
“PSH” appears in the display. If Start is not pressed within 1 minute after pressing a keypad, the 
function is canceled and the time of day is displayed.
CANCEL/OFF
Range function
The Cancel/Off keypad stops any function except the Clock, Timer, and Oven Control Lockout.
TEMP/HOUR
Temperature and 
time adjust
The “More” or “Less” arrow pads are used to adjust time and temperature settings.
KEYPAD
FEATURE
INSTRUCTIONS
WARNING
Fire Hazard
Do not let the burner flame extend beyond the edge of 
the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in death 
or fire.
REMEMBER: When range is in use or (on some models) 
during the Self-Cleaning cycle, the entire cooktop area may 
become hot.
A. Burner cap
B. Burner base
C. Alignment pins
D. Igniter
E. Gas tube opening
A. 1-1
¹⁄₂" (25-38 mm)
B. Burner ports
A
B
D
E
C
B
A