Bertazzoni X)486GPIRVI Benutzerhandbuch

 

41

Range does not function 

Range is not connected to electrical power. Ask a professional to check 
power circuit breaker, wiring and fuses. 

Self‐clean cycle does not activate  Door is not shut tight enough for automatic door latch to lock 

Broil does not work 

Temperature control knob is rotated too far past broil position (500°F); 
PRE‐HEATING indicator will light intermittently 

Door does not open 

Oven is still in self‐clean mode. Door latch will release when safe 
temperature is reached. 

Oven light does not work  

Light bulb is burned out. Range is not connected to power/ clean is cycle 
on 

Igniters does not work 

Circuit is tripped. Fuse is blown. Range is not connected to power. 

Igniters sparking but no flame 
ignition 

Gas supply valve is in “OFF” position. Gas supply is interrupted. 

Igniters spark continuously after 
flame ignition 

Ignition micro‐switches remain incorrectly engaged; call a qualified 
technician for repair. 

Burner ignites but flame is large, 
distorted, or yellow 

Burner ports are clogged. Unit is not set to the appropriate gas type. Call 
a qualified technician for gas conversion procedure. 

Oven door is locked and will not 
release, even after cooling 

Turn the oven off at the circuit breaker and wait 5 minutes. Turn breaker 
back on. The oven should reset itself and will be operable. 

Oven is not heating 

Check the circuit breaker or fuse box to your house. Make sure there is 
proper electrical power to the oven. Make sure the oven temperature 
has been selected. 

Oven light is not working 
properly 

Replace or reinsert the light bulb if loose or defective.  

Oven light stays on 

Check for obstruction in oven door. Check to see if hinge is bent. 

Cannot remove lens cover on 
light 

There may be soil build‐up around the lens cover. Wipe lens cover area 
with a clean dry towel prior to attempting to remove the lens cover. 

PRE‐HEATING indicator lights up 
intermittently and sound alarm 
on 

This is a FAULT alarm indicating the failure of the cooling fan/s. Try 
resetting by turning both selectors to the OFF position. If the error is not 
repaired, call a qualified technician for diagnosis and repair. If not 
repaired, this error indicator will appear again within 10 seconds once 
the oven is activated in any functions for which cooling fans are required 
to operate, preventing the use of the oven. Set both selectors to OFF 
position and call a qualified technician for repair. 

HEATING indicator light turned 
on intermittently and with sound 
alarm on 

This is a FAULT indicating failure of the oven sensor temperature probe; 
in this case cooling fans will start automatically. To reset, switch both 
selector to the OFF position.  To stop buzzer and light indicator, 
disconnect the appliance from the main electrical supply and call a 
qualified technician for repair. 

CLEAN indicator light on 
intermittently and sound alarm 
on 

Electrical power failure happening during cleaning cycle operation; 
cleaning cycle interrupted; cooling fans remains both activated; the 
error will be reset by putting two selectors in OFF position; repeat 
cleaning cycle if needed after 3‐4 hours. 

CLEAN indicator light turned on 
intermittently, sound alarm off 

Interruption/Stop of an incomplete cleaning cycle due to a intentional or 
accidental displacement of one of the two oven selectors from CLEAN 
position during cleaning cycle operation; put both selectors in OFF