Blomberg KNM1551i Benutzerhandbuch

Seite von 25
EN
9
INSTALLATION 
INSTRUCTIONS
1. The space in the room where the 
appliance is installed must not be 
smaller than 10 cubic metres.
 2. See for detailed Installation 
Instructions including reversing door 
opening direction.
3. This appliance has been designed 
to operate in ambient temperatures up 
to 32 degrees C (90 degrees F) and 
is equipped with Advanced Electronic 
Temperature Control System [AETCS] 
which ensures that at the advised 
setting [4 - four on the knob] the frozen 
food in the freezer will not defrost 
even if the ambient temperature falls 
as low as -15 °C. When first installed 
the product MUST NOT be placed in 
low ambient temperatures because 
the freezer will not reduce to it’s 
standard operating temperature. Once 
it has reached its steady operating 
state it can be re-located. So you 
may  then  install your appliance in a 
garage or an unheated room without 
having to worry about frozen food in 
the freezer being spoilt. However at 
low ambient temperatures mentioned 
above, fridge contents are likely 
to freeze, so check and consume 
food in the fridge accordingly. When 
the ambient temperature returns to 
normal, you may change the knob 
setting to suit your needs.
If the ambient temperature is 
below 0°C, the food in the fridge 
compartment will freeze. So, we 
recommend you don’t use the fridge 
compartment in such low ambient 
conditions. You can continue using the 
freezer compartment as usual.
4.Do not place the appliance near 
cookers, radiators or in direct sunlight 
as this will cause your appliance to 
work harder. If installed next to a 
source of heat or freezer, maintain the 
following minimum side clearances:
From Cookers  50 mm (2”)
From Radiators  300 mm (12”)
From Freezers   25 mm (1”)
5. Refer to cleaning and care section 
to prepare your appliance for use. 
6.A special receptacle is supplied to 
store the mains plug during transit. 
The receptacle is fixed at the back 
of the cabinet, on the side of the 
compressor. (See diagram) Gently 
remove the plug from the receptacle. 
Never pull the mains cord, you may 
damage the appliance. In the case 
of transportation, ensure you locate 
the plug in the receptacle provided to 
avoid transit damage.