Norcold 452 Benutzerhandbuch

The refrigerators described herein are certified un-

der the latest edition of ANSI Z21.19 Standards by
the American Gas Association (A.G.A.) for installa-
tion in mobile home or recreational vehicle and ap-
proval by the Canadian Gas Association (CGA). 

Installation must be made in accordance with these

standards and with the installation instructions pro-
vided in this manual for the Norcold factory warranty
to be in effect.

Installation must conform with local codes, or in the

absence of local codes, with the following standards
as applicable:

In the United States:

a. National Fuel Gas Code, ANSI Z223.1. 
b.  Manufactured Home Construction and Safety

Standard, Title 24 CFR, Part 23-80.

c. 

Standard for Recreational Vehicles,ANSI
A119.2, latest edition.

When an external electrical energy is utilized, the

refrigerator must be electrically  grounded in accord-
ance with local codes, or in the absence of local
codes, the National electrical Code, ANSI/NFPA 70.

In Canada:

a. Current CGA B149.1 and B149.2 installation

code for Propane Appliances and Equipment..

b. Current CSA Z240.4.2 installation code for Pro-

pane Appliances and Equipment in Recrea-
tional Vehicles.

c. Current CSA Z240.6.2/C22.2 No. 148 Electrical

Requirement for Recreational Vehicles. 

When installed, the appliance must be electrically

grounded in accordance with the current Canadian
Electrical Code C22.2 Parts 1 and 2.

The refrigerators certified for built installation and

requires cut-out dimensions as indicated in Table 2
below.

Combustion seals (foam strips) are attached to the

back surface of the refrigerator’s mounting flanges.
These seals isolate the products of combustion from
the vehicle’s living space. The seals must be con-
tinuous between the wall and the mounting
flanges to  assure a complete combustion seal.
When installing or removing the refrigerator, insure
that the seals are not missing or damaged. 

The lower mounting flange and mounting screws

are located in a clear plastic bag positioned in the
coils at the rear of the refrigerator. After removing the
plastic bag, slide the refrigerator partially into the en-
closure and attach the lower mounting flange. Install
the lower mounting flange by maneuvering it under
the bottom control cover and secure with the screws
provided. Refer to Figure 7.  Do not omit installa-
tion of the lower mounting flange. This flange is
part of the combustion seal.

Secure the refrigerator with screws through the

mounting flange holes at the front of the refrigerator
and the holes at floor level at the rear of the refrig-
erator. Screw covers are provided to cover the front
mounting flange holes.

TABLE 2
REFRIGERATOR CUT-OUT OPENINGS (INCHES)

Model

462, 463
482, 483

452,453
442,443

Height
52 7/8
59 7/8
43 1/4
30 7/8

Width

23 1/2
23 1/2
23 1/2
23 1/2

Depth

24
24
24
24

Figure 7