Master Bilt CMICL-156 Benutzerhandbuch
14
6.
Compressor will not start – hums, but cycles on overload
A. Low
voltage.
B. Relay
defective.
C. Overload
defective.
D.
High head pressure (see 1).
7.
Special service situations
If moisture or liquid is observed around or under a Master-Bilt cabinet, an immediate investigation
should be made by qualified personnel to determine the source of moisture or liquid. The investigation
made should determine if the cabinet is malfunctioning or if there is a simple housekeeping problem.
Moisture or liquid around or under a cabinet is a potential slip/fall hazard for persons walking by or
working in the general area of the cabinet.
Any cabinet malfunction or housekeeping problem that creates a slip/fall hazard around or under a
cabinet should be corrected immediately.
should be made by qualified personnel to determine the source of moisture or liquid. The investigation
made should determine if the cabinet is malfunctioning or if there is a simple housekeeping problem.
Moisture or liquid around or under a cabinet is a potential slip/fall hazard for persons walking by or
working in the general area of the cabinet.
Any cabinet malfunction or housekeeping problem that creates a slip/fall hazard around or under a
cabinet should be corrected immediately.
MASTER-BILT PART NUMBERS
The table below gives Master-Bilt part numbers. Use this chart when ordering replacement parts for your
CM/CM cases.
Description CM/CL-156
Qty
R35E-070UU
1
SK#3 & 3A
R35XZ070UU
1
SK # 1
C12X-070UU
4
SK # 1
W46X-070UU
3
28X63-RH-NSF-1092-DGT-SK#2-2P-
D28RX070UU
1
F35E-07-UU 1
F35S-070UU
1
TOTALS
12
Vapor Proof Light Globe(for door panel)
23-00594
1
1 " Dia. Gray Plug Buttons
29-01287
70
1 " Dia. Chrome Plug Buttons
29-01300
8
5/16" Hex Cam Wrench
35-0180
1
SALE AND DISPOSAL
OWNER RESPONSIBILITY
If you sell or give away your Master-Bilt cabinet you must make sure that all safety labels and the Installation-
Service Manual are included with it. If you need replacement labels or manuals, Master-Bilt will provide them
free. Contact the customer service department at Master-Bilt at (800) 684-8988.
The customer service department at Master-Bilt should be contacted at the time of sale or disposal of your
cabinet so records may be kept of its new location.
If you sell or give away your Master-Bilt cabinet and you evacuate the refrigerant charge before shipment,
Master-Bilt recommends that the refrigerant charge be properly recovered
in compliance with section
608
of the Clean Air Act effective November 1995 and in accordance with all applicable local, regional, or national
standards.
standards.