Thermador KBULT3665E Benutzerhandbuch

Seite von 48
6
IMPORTANT: Because air circulates between both sections, any 
odors formed in one section will transfer to the other. You must 
thoroughly clean both sections to eliminate odors. To avoid odor 
transfer and drying out of food, wrap or cover foods tightly.
U s i n g   t h e   C o n t ro l s
IMPORTANT: 
The refrigerator control adjusts the refrigerator compartment 
temperature. The freezer control adjusts the freezer 
compartment temperature.
Wait 24 hours after you turn on the refrigerator before you put 
food into it. If you add food before the refrigerator has cooled 
completely, your food may spoil. 
NOTE: Adjusting the refrigerator and freezer controls to a 
lower (colder) setting will not cool the compartments any 
faster.
If the temperature is too warm or too cold in the refrigerator or 
freezer, first check the air vents to be sure they are not 
blocked before adjusting the controls.
The preset settings should be correct for normal household 
usage. The controls are set correctly when milk or juice is as 
cold as you like and when ice cream is firm.
The actual temperature may differ from the display when a 
door is open for an extended period of time.
NOTE: The factory recommended set points are 0°F (-18°C) 
for the freezer and 37°F (3°C) for the refrigerator.
Turning Refrigerator On and Viewing Set Points
Press and hold POWER (ON/OFF) for 2 seconds. 
Viewing the Celsius Temperatures
Press °C SELECT touch pad. The negative sign (-) will light 
up. To redisplay degrees Fahrenheit, press °C SELECT again. 
NOTE: If the freezer temperature is below zero, the negative sign 
next to the freezer display will light up. This is normal. 
Adjusting Controls 
NOTE: Wait at least 24 hours between adjustments. Recheck the 
temperatures before other adjustments are made.
To adjust set point temperatures:
Press the refrigerator or freezer PLUS (+) or MINUS (-) key 
pad until the desired temperature is reached.
NOTE: The set point range for the freezer is -5°F to 6°F (-21°C to 
-14°C). The set point range for the refrigerator is 34°F to 46°F 
(1°C to 8°C).  
Water Filter Status & Reset 
The water filter display will help you know when it is time to 
change your filter. To change the filter, see the “Water Filtration 
System” section.  
After replacing the water filter, press RESET and hold for 
2 seconds to change the water filter display to 99 percent. 
Holiday Feature 
The Holiday feature is designed for the traveler or for those 
whose religious observances require turning off the lights and ice 
maker. By selecting this feature, the temperature set points 
remain unchanged, the ice maker will be disabled and the interior 
lights will turn off. For most efficient refrigerator operation, it is 
recommended to exit the Holiday feature when it is no longer 
required.
Press HOLIDAY to turn on the Holiday feature. This feature 
will remain on until the Holiday key is pressed again.
CONDITION/REASON:
TEMPERATURE 
ADJUSTMENT:
REFRIGERATOR too cold
Not set correctly for conditions
REFRIGERATOR Control 1° 
higher
REFRIGERATOR too warm
High use or room very warm
REFRIGERATOR Control 1° 
lower 
FREEZER too cold
Not set correctly for conditions
FREEZER Control 1° higher 
FREEZER too warm/too little 
ice 
High use or heavy ice use
FREEZER Control 1° lower
INDICATOR:
STATUS:
99 percent 
New filter installed
10 percent
Order replacement filter
0 percent or flow decreases
Replace filter
Do not use with water that is microbiologically unsafe or 
of unknown quality without adequate disinfection before 
or after the system. Systems certified for cyst reduction 
may be used on disinfected waters that may contain 
filterable cysts.