Samsung RF4289HAR Benutzerhandbuch

setting up 

01

 

SETTING

 UP

ADJUSTING THE FREEZER 
DRAWER LEVEL

1.  Locate the height-adjuster ( 

1 ) in the freezer 

drawer. Unscrew the 8 Phillips screws ( 

2 ) 

slightly to loosen the door.

2.  Loosen the controller screw 

( 

3 ) with a Phillips screwdriver 

(+).

3.  Find the best level to align the door slope.
•  After adjustment, tighten the controller screw 

( 

3 ) and then the philips screws.

INSTALLING THE WATER 
DISPENSER LINE

A water dispenser with a filter is one of the helpful 
features on your new refrigerator. To help promote 
better health, the water filter removes unwanted 
particles from your water. However, it does not 
sterilize or destroy microorganisms. You may need 
to purchase a water purifying system to do that.
In order for the ice maker to operate properly, a 
water pressure of 20~125 psi is required.
Under normal conditions, a 170 cc (5.75 oz.) cup 
can be filled in about 10 seconds.
If the refrigerator is installed in an area with low 
water pressure (below 20psi), you can install a 
booster pump to compensate for the low pressure.
After you have connected the water line, make 
sure the water storage tank inside the refrigerator is 
properly filled. To do this, press the water dispenser 
lever until the water runs from the water outlet.

Water line installation kits are available at 
extra cost from your dealer. 
We recommend using a water line 
installation kit that contains copper tubing 
and ¼” compression nut.

Connecting to the water supply line

1.  First, shut off the main water 

supply.

2.  Locate the nearest cold water drinking line and 

install the pipe clamp and shut off valve.

3.  Connect the water line installation kit to the shut 

off valve.

Freezer Drawer

Adjustment part

1

2

Example) The slope is about 0.08inch (2mm) as shown below.
-  Rotate the height adjuster to -2.0 to reduce the door slope.

Slope

Reference plane

3

DA68-02520A-13.indb   11

2013. 12. 2.   �� 5:08