Broan QS236BL Benutzerhandbuch

Page 4

ALLURE

QS2 SERIES

RANGE HOOD

PREPARE THE HOOD

Remove appropriate

Duct Knockout(s) from top or back of

hood.

REAR

RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10”

Horizontal Discharge)

TOP RECTANGULAR

DUCT KNOCKOUT

(Remove for 3¼” x 10”

Vertical & for 7” Round

Discharge)

SEMI-CIRCULAR

DUCT KNOCKOUT

(Remove for 7” Round

Discharge)

12 Horizontal Discharge Only: Remove the

Plate in front of the

horizontal discharge knockout. Cut the

Ties, lift plate out, and

discard plate. DO NOT REMOVE the

Metal Strip held in place

with two

Screws.

TIES

PLATE

METAL STRIP

SCREW

PREPARE THE HOOD

14 7” Round Ducted Discharge Only: Re-install

7” Round Duct

Plate removed in Step #1 under “PREPARE THE HOOD”.

Install a 7” round damper (purchase separately). Damper

flap must open freely in direction of airflow (away from range

hood).

13 3¼” x 10” Ducted Discharge Only: Remove

Tape from damper

flap and attach

Damper/Duct Connector over knockout

opening with screws removed in Step 4 under “PREPARE

THE HOOD”. Make sure damper

Pivot is nearest to Top/Back

Edge of hood.

DAMPER/

DUCT

CONNECTOR

(Vertical discharge

position shown)

TAPE

UP TO 1”

SIDE-TO-SIDE
ADJUSTMENT

PIVOT

TOP/BACK

EDGE

NOTE

To accomodate off-center ductwork, the Damper/Duct

Connector can be installed up to 1-inch on either side of

hood center or the 7” Round Duct Plate can be installed

up to ½” on either side of hood center. In extreme off-center

installations, one end of the duct connector may need to be trimmed

to clear the electrical cable clamp.



15 Non-Ducted Installations Only: Require a

Performance Ring

to be attached to the blower wheel.

To install ring:

1. Remove the

Blower Wheel by rocking it side to side and

applying a slight force to pull wheel from motor. Remove

Retaining Ring if necessary.

2. Slide the ring onto the

Small Diameter End of the wheel

and down to the

Stop Edge of the wheel.

3. Reassemble wheel to motor. Make sure

Tab on wheel fits

into one of the

Motor Slots.

4. Push wheel down until it is locked in place.

5. Check that wheel is properly positioned as shown. Press

Sections into place if necessary. Make sure wheel turns

freely.

BLOWER

WHEEL

TAB

SECTIONS

SMALL DIAMETER

END

STOP

EDGE

RING

MOTOR

SLOTS

RETAINING

RING